Brush Bullet Applicator (aka. Brush Pod) Reverse Modeling

Engineering
1

Disclaimer: This model is for dimensions and educational purposes only and should not be manufactured or even been use as an actual equipment.

All the model features are measured or estimated depends on Thomas’s photo in the discord thread.

The reason I decided to do this modeling because I expected there’s possible layout requirements in these days. I may or may not consider submit a grant for this in future (hesitating for a price of ramen for three persons).

Due to the limit of measurement methods, this is not a fully detailed model, and parts may also have several millimeters of deviations. Currently recommended for aircraft layout reference use only…

image
image1244×1028 85.7 KB

image
image816×1224 89.4 KB

image
image1046×974 55.3 KB

Onshape link to the assembly:

Important message:

image

2 Likes
2

Good work KBM! It was much needed. I especially like your use of the constraints for the lid :smile:

1 Like
3

That may help when analysing the clearance for operating, also can kill time by playing it aggressively

4

J E L L Y
B E A N
O N L Y

Great work!

1 Like
5

That’s great KBM, you can create a grant application for this. Another grant on top of this might be modifying the design according to Project Quiver attachment interface. We can discuss the details of the second leg of this project when we have the proper attachment interface!

1 Like